Each system consists of:

• Bypass System with diverter damper, expansion joints and stack
• Transition duct sections and main stack
• Convective Section with coil assembly for steam generation
• Duct Burner System with three horizontal elements. Each system complete with main and pilot gas headers, redundant skid-mounted scanner cooling air blowers and an integral exhaust gas flow distribution grid
• Fuel gas skid
• Burner management system
• Feed water high pressure pump
• Feed water heat exchanger
• Steam separator, designed for 99.95% separation efficiency
• Air-cooled heat exchanger
• All interconnect pipes and valves.
• Modified ISO climate control container for housing of the control panel and MCC/VFD panel. The control system automatically adjusts the fuel – water ratio parameter to keep the steam quality at 80% at all operating levels.
• EN-FAB's HRSG systems are custom designed to meet your desired operating performance requirements. Our well qualified and experienced personnel can also supervise field installation, start-up and commissioning of the units

Used to reduce the level of suspended solids in feed water applications, EN-FAB high rate, multi media water filter design is effective in removing rust, dirt, silt, and other suspended solids from water down to 5 to 10 microns. The effectiveness increases the industry's ability to conserve, treat and recycle large amounts of water.

Older sand filter systems depend on bacterial action for water purification, while rapid sand filters, which operate on a surface effect principle, make use of disinfectants and coagulants to accomplish the same objective. Extensive investigative research of filter media and improved coagulants have made high-rate filtration practical and efficient.